Physical Interface
LED
| LEDs | |
|---|---|
| PWR | When power is supplied, BLUE lights up. |
| TX | During data transmission in RF communication, BLUE blinks. |
| RX | During data reception in RF communication, BLUE blinks. |
| RSSI | Indicates signal strength in RF communication.
Off: No Signal Red: Poor Signal Strength Yellow: Medium Signal Strength Green: Good Signal Strength |
| Inputs 1 - 8 | When a signal is applied to the digital input, BLUE lights up. |
| Outputs 1 - 4 | When the digital output signals, BLUE lights up. |
Inputs/Outputs
| Digital Inputs | |
|---|---|
| Isolation | Isolated digital inputs, 3.5 kV RMS isolation protection. |
| Input Voltage | 10 - 26 VDC input. |
| Input Group 1 | I1, I2, I3, I4 digital inputs. C1 COM. |
| Input Group 2 | I5, I6, I7, I8 digital inputs. C2 COM. |
| Digital Outputs | |
|---|---|
| Output Type | Relay - SPST - NO(1 Form A) |
| Maximum Contact Voltage | DC: 3 A, 24 VDC AC: 5 A, 250 VAC |
| Outputs | O1: NO normally open, CM COM.
O2: NO normally open, CM COM. O3: NO normally open, CM COM. O4: NO normally open, CM COM. |
| Analog Inputs | |
|---|---|
| Input Range | 0 - 10 VDC / 4 - 20 mA input. |
| Input 1 | AN1+ AN1- |
| Input 2 | AN2+ AN2- |
| Reset Button | |
|---|---|
| Hold for 1 Second | The device restarts. |
| Hold for 5 Seconds | The device settings return to default values. |
| Hold for 10 Seconds | The device returns to factory firmware. |
| Antennas | |
|---|---|
| RF Antenna | 1x SMA female 50 Ohm |
| Wi-Fi Antenna | 1x SMA female 50 Ohm |
| RS485 Interface | |
|---|---|
| RS485 Terminal Block | RS485 A, B, G terminal block 3x3.81 mm |
| Connection Type | RS485 2 Wire |
| Protection | 15 kV ESD Protection, GDT Protection |
| Baud Rate | 300, 600, 1200, 2400, 4800, 9600, 19200, 83400, 57600, 115200 |
| Parity Bits | Odd, Even, None |
| Stop Bit | 1, 1.5, 2 |