Physical Interface

LED

LEDs
Power LED	Blue: Power On
	Off: No Power
ACT	Blue (On - Off): Normal Operating Status
	Off: Error Status
Network	Blue: Connected to Internet
	Off: Not Connected to Internet
RSSI LED	Blue: Excellent Signal Quality
	Green: Moderate Signal Quality
	Red: Poor Signal Quality
	Off: No Network
Digital Input LED	Blue: High input level
	Off: Low input level
Digital Output LED	Blue: Relay on
	Off: Relay off

Inputs/Outputs

Digital Inputs
Isolation	Isolated digital inputs, 3.5 kV RMS isolation protection.
Input Voltage	10 - 24 VDC input.
Input Group 1	IN1, IB2, IN3, IN4 digital inputs. ICM1 COM.
Input Group 2	IN5, IN6, IN7, IN8 digital inputs. ICM2 COM.

Digital Outputs
Output Type	Relay - SPST - NO(1 Form A)
Maximum Contact Voltage	DC: 3 A, 24 VDC AC: 5 A, 250 VAC
Outputs	O1N: NO normally open, OCM1 COM. O2N: NO normally open, OCM1 COM. O3N: NO normally open, OCM2 COM. O4N: NO normally open, OCM2 COM.

Analog Inputs
Input Range	0 - 10 VDC / 4 - 20 mA input.
Input 1	AIN1+ AIN1-
Input 2	AIN2+ AIN2-

Analog Outputs
Output Range	0 - 10 VDC
Output 1	AOUT+ AOUT-

Reset Button
Press and Hold for 1 Second	The device will restart.
Press and Hold for 5 Seconds	The device settings will revert to default values.
Press and Hold for 10 Seconds	The device will revert to factory firmware.

Antennas
LTE Antenna	1x SMA female 50 Ohm
Wi-Fi Antenna	1x SMA female 50 Ohm

SIM Card
SIM Card Slot	SIM Card Slot.

RS485 Interface
RS485 Terminal Block	RS485 A, B, G terminal block 3x3.5 mm
Connection Type	RS485 2 Wire
Protection	15 kV ESD Protection, GDT Protection
Baud Rate	300, 600, 1200, 2400, 4800, 9600, 19200, 83400, 57600, 115200
Parity Bits	Odd, Even, None
Stop Bit	1, 1.5, 2

RS232 Interface
RS232 Terminal Block	RS232 Rx, Tx, VCC, GND terminal block 4x3.5 mm
Connection Type	RS232 4 Wire
Protection	15 kV ESD Protection, GDT Protection
Baud Rate	300, 600, 1200, 2400, 4800, 9600, 19200, 83400, 57600, 115200
Parity Bits	Odd, Even, None
Stop Bit	1, 1.5, 2